CJDPC - FAST SETTING CONCRETE 1004

  • MSDS: CJDPC
  • Manufacturer: THE QUIKRETE COMPANIES
  • Product Name: FAST SETTING CONCRETE 1004
  • National Stock Number: 5610-00F015552
Product Identification

Product ID:FAST SETTING CONCRETE 1004
MSDS Date:09/01/1996
FSC:5610
NIIN:00F015552
Status Code:A
MSDS Number: CJDPC

Responsible Party
THE QUIKRETE COMPANIES
2987 CLAIRMONT ROAD SUITE 500
ATLANTA, GA 30295
US

Emergency Phone: 770-216-9580

Cage: JO056

Contractor
THE QUIKRETE COMPANIES
ATLANTA, GA 30295 US

Telephone: 404-634-9100

Cage: JO056

Ingredients

SILICA SAND, CRYSTALLINE

CAS: 14808-60-7

RTECS: VV7330000

OSHA PEL 0.1 MG/M3

ACGIH TLV: 0.1 MG/M3


CEMENT, PORTLAND

CAS: 65997-15-1

RTECS: VV8770000

OSHA PEL 5 MG/M3

ACGIH TLV: 5 MG/M3


LIME

CAS: 1305-62-0

RTECS: EW2800000

OSHA PEL 5 MG/M3

ACGIH TLV: 5 MG/M3


AMORPHOUS SILICA FROM FLY ASH

CAS: 7631-86-9

OSHA PEL 80 MG/M3

ACGIH TLV: 10 MG/M3


ALUMINA FROM FLY ASH

CAS: 1344-28-1

RTECS: BD1200000

OSHA PEL 5 MG/M3

ACGIH TLV: 5 MG/M3


LIMESTONE DUST

CAS: 1317-65-3

RTECS: EV9580000

OSHA PEL 5 MG/M3

ACGIH TLV: 5 MG/M3

Hazards

Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:YES IARC:YES OSHA:NO
Health Hazards Acute and Chronic:SKIN: CAN CAUSE ALKALI BURNS & EFFECT
THE MUCOUS MEMBRANES. MAY IRRITATE EYES & UPPER RESPIRATORY SYSTEM.
OVEREXPOSURE CAN CAUSE INFLAMMATION OF THE LINING TISSUE OF THE
INTERIOR OF THE NOSE & INFLAMM ATION OF THE CORNEA. HYPERSENSITIVE
INDIVIDUALS MAY DEVELOP AN ALLERGIC DERMATITIS. EXCESSIVE
INHALATION MAY RESULT IN RESPIRATORY DISEASE, INCLUDING SILICOSIS,
PNEUMOCONIOSIS, PULMONARY FIBROSIS & PO SSIBLY CANCER.
Explanation of Carcinogenicity:1992, NTP, 6TH ANNUAL REPORT ON
CARCINOGEN, IDENTIFIED RESPIRABLE CRYSTALLINE SILICA: SUBSTANCE
ANTICIPATED TO BE A HUMAN CARCINOGEN. IARC MONOGRAPHS ON EVALUATION
OF CARCINOGENIC RISK OF CHEMICAL T O HUMANS CONCLUDES SUFFICIENT
EVIDENCE OF CARCINOGENICITY TO EXPERIMENTAL ANIMALS & LIMITED
EVIDENCE OF THE CARCINOGENICITY OF CRYSTALLINE SILICA TO HUMANS.
Effects of Overexposure:DRYNESS OF SKIN, BURNS, INFLAMMATION, SHORTNESS
OF BREATH, CAUSTIC BURNS, REDUCED PULMONARY FUNCTION.
Medical Cond Aggravated by Exposure:INDIVIDUALS W/SENSITIVE SKIN &
W/PULMONARY/RESPIRATORY DISEASE; ASTHMA, BRONCHITIS. EYE
IRRITATION.

First Aid

First Aid:EYES: IRRIGATE/FLOOD IMMEDIATELY & REPEATEDLY W/CLEAN WATER.
SKIN: WASH W/SOAP & WATER. INHALATION: REMOVE IMMEDIATELY TO FRESH
AIR, GIVE CPR AS NEEDED. OBTAIN MEDICAL ATTENTION IN ALL CASES.

Fire Fighting

Flash Point:NONCOMBUSTIBLE
Unusual Fire/Explosion Hazard:CONTACT W/OXIDIZING AGENTS MAY CAUSE
FIRES.

Accidental Release

Spill Release Procedures:USE DUSTLESS METHODS/VACUUM & PLACE INTO
CLOSABLE CONTAINER FOR DISPOSAL/USE IF NOT CONTAMINATED/WET. USE
ADEQUATE VENTILATION.

Handling

Handling and Storage Precautions:THE USE OF BARRIER CREAMS/IMPERVIOUS
GLOVES, BOOTS & CLOTHING TO PROTECT THE SKIN FROM CONTACT IS
RECOMMENDED. FOLLOWING WORK, WORKERS SHOULD SHOWER W/SOAP& WATER.
Other Precautions:PRECAUTIONS MUST BE OBSERVED BECAUSE BURNS OCCUR
W/LITTLE WARNING/LITTLE HEAT IS SENSED. CUSTOMERS-USERS MUST COMPLY
W/ALL APPLICABLE HEALTH & SAFETY LAWS, REGULATIONS & ORDERS
COVERING SILICA.

Exposure Controls

Respiratory Protection:IN DUSTY ENVIRONMENTS, THE USE OF AN OSHA,
MSHA/NIOSH APPROVED RESPIRATOR IS RECOMMENDED.
Ventilation:LOCAL EXHAUST TO CONTROL AIRBORNED DUST LEVELS.
Protective Gloves:IMPERVIOUS
Eye Protection:TIGHT FITTING GOGGLES
Other Protective Equipment:BARRIER CREAMS, IMPERVIOUS BOOTS & CLOTHING
Work Hygienic Practices:FOLLOWING WORK, WORKERS SHOULD SHOWER W/SOAP &
WATER.
Supplemental Safety and Health
INHALATION: OVEREXPOSURE OF SILICA DUST MAY RESULT IN RESPIRATORY
DISEASE, SILICOSIS, PNEUMOCONIOSIS, PULMONARY FIBROSIS & POSSIBLE
CANCER.

Chemical Properties

Solubility in Water:SLIGHT
Appearance and Odor:GRAY TO GRAY-BROWN COLORED POWDER W/NO ODOR.

Stability

Stability Indicator/Materials to Avoid:YES
OXIDIZING AGENTS; FLUORINE, CHLORINE TRIFULORIDE, MANGANESE TRIOXIDE,
OXYGEN DIFLUORIDE
Hazardous Decomposition Products:SILICA WILL DISSOLVE IN HYDROFLUORIC
ACID & PRODUCE A CORROSIVE GAS SILICON TETRAFLUORIDE
Conditions to Avoid Polymerization:KEEP DRY UNTIL USED TO PRESERVE
PRODUCT UTILITY.

Disposal

Waste Disposal Methods:CAN BE TREATED AS COMMON WASTE. DISPOSE OF IN
ACCORDANCE W/LOCAL, STATE & FEDERAL REGULATIONS.

Other Information

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.